Set Igmp Mcrtexpiretime; Set Igmp Mrouter - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

13.1.6 set igmp mcrtexpiretime

This command sets the Multicast Router Present Expiration time. The time is set for the
system, on a particular interface or VLAN.
This is the amount of time in seconds that a switch waits for a query to be received on an
interface before the interface is removed from the list of interfaces with multicast routers
attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-out, i.e. no
expiration.
Default
Format
Modes
13.1.6.1 no set igmp mcrtexpiretime
This command sets the Multicast Router Present Expiration time to 0. The time is set for
the system, on a particular interface or a VLAN.
Format
Modes

13.1.7 set igmp mrouter

This command configures the VLAN ID (<
enabled.
Format
Mode
13.1.7.1 no set igmp mrouter
This command disables multicast router mode for a particular VLAN ID (<
Format
Mode
IGMP Snooping Commands
0
set igmp mcrtexpiretime <vlanId> <0-3600>
Global Config
Interface Config
no set igmp mcrtexpiretime <vlanId>
Global Config
Interface Config
vlanId
set igmp mrouter <vlanId>
Interface Config
no set igmp mrouter <vlanId>
Interface Config
v1.0, March 2006
>) that has the multicast router mode
>).
vlanId
13-5