Show Trapflags - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Format
Mode
SNMP Trap Name
IP Address
Status

10.2.3 show trapflags

This command displays trap conditions. Configure which traps the switch should generate
by enabling or disabling the trap condition. If a trap condition is enabled and the condition
is detected, the SNMP agent on the switch sends the trap to all enabled trap receivers. You
do not have to reset the switch to implement the changes. Cold and warm start traps are
always generated and cannot be disabled.
Format
Mode
Authentication
Flag
Link Up/Down
Flag
Multiple Users
Flag
Spanning Tree
Flag
Broadcast Storm
Flag
DVMRP Traps
SNMP Commands
show snmptrap
Privileged EXEC
The community string of the SNMP trap packet sent to the
trap manager. The string is case sensitive and can be up to 16
alphanumeric characters.
The IP address to receive SNMP traps from this device.
Indicates the receiver's status (enabled or disabled).
show trapflags
Privileged EXEC
Can be enabled or disabled. The factory default is enabled.
Indicates whether authentication failure traps will be sent.
Can be enabled or disabled. The factory default is enabled.
Indicates whether link status traps will be sent.
Can be enabled or disabled. The factory default is enabled.
Indicates whether a trap will be sent when the same user ID is
logged into the switch more than once at the same time
(either via telnet or serial port).
Can be enabled or disabled. The factory default is enabled.
Indicates whether spanning tree traps will be sent.
Can be enabled or disabled. The factory default is enabled.
Indicates whether broadcast storm traps will be sent.
Can be enabled or disabled. The factory default is disabled.
Indicates whether DVMRP traps will be sent.
v1.0, March 2006
10-11