Enable; Serviceport Ip; Serviceport Protocol; Network Parms - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

3.1.1 enable

This command gives you access to the Privileged EXEC mode. From the Privileged
EXEC mode, you can configure the network interface.
Format
Mode

3.1.2 serviceport ip

This command sets the IP address, the netmask and the gateway of the network
management port.
Format
Mode

3.1.3 serviceport protocol

This command specifies the network management port configuration protocol. If you
modify this value, the change is effective immediately. If you use the
the switch periodically sends requests to a BootP server until a response is received. If you
use the parameter, the switch periodically sends requests to a DHCP server until a
dhcp
response is received. If you use the
information for the switch manually.
Format
Mode

3.1.4 network parms

This command sets the IP Address, subnet mask and gateway of the device. The IP
Address and the gateway must be on the same subnet.
Format
Mode

3.1.5 network mgmt_vlan

This command configures the Management VLAN ID.
Default
Format
Mode
3-2
enable
User EXEC
serviceport ip <ipaddr> <netmask> [gateway]
Privileged EXEC
parameter, you must configure the network
none
serviceport protocol {none | bootp | dhcp}
Privileged EXEC
network parms <ipaddr> <netmask> [<gateway>]
Privileged EXEC
1
network mgmt_vlan <1-4069>
Privileged EXEC
v1.0, March 2006
parameter,
bootp
Administrative Access Commands