Show Logging; Show Mac-Addr-Table - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Time Since
Counters Last
Cleared

15.1.6 show logging

This command displays the trap log that the switch maintains. The trap log contains a
maximum of 256 entries that wrap.
Note: Trap log information is not retained across a switch reset.
Format
Mode
Number of Traps
since last reset
Number of Traps
since log last
displayed
Log
System Up Time
Trap

15.1.7 show mac-addr-table

This command displays the forwarding database entries. If the command is entered with
no parameter, the entire table is displayed. This is the same as entering the optional
parameter. Alternatively, the administrator can enter a MAC Address to display the table
entry for the requested MAC address and all entries following the requested MAC
address.
15-14
VLAN Deletes - The number of VLANs on this switch that
have been created and then deleted since the last reboot.
The elapsed time, in days, hours, minutes, and seconds, since
the statistics for this switch were last cleared.
show logging
Privileged EXEC
The number of traps that have occurred since the last reset.
The number of traps that have occurred since the traps were
last displayed. Getting the traps by any method (terminal
interface display, Web display, upload file from switch etc.)
sets the counter to 0.
The sequence number of this trap.
The relative time since the last reboot of the switch at which
this trap occurred.
The relevant information of this trap.
v1.0, March 2006
System Maintenance Commands
all