Show Access-Lists - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Destination IP
Address
Destination IP
Mask
Destination Ports
Service Type Field
Match
Service Type Field
Value

14.8.4 show access-lists

This command displays IP ACLs and MAC access control lists information for a
designated interface and direction.
Format
Mode
ACL Type
ACL ID
Sequence
Number
Quality of Service (QoS) Commands
This displays the destination IP address for this rule.
This field displays the destination IP Mask for this rule.
This field displays the destination port for this rule.
This field indicates whether an IP DSCP, IP Precedence, or IP
TOS match condition is specified for this rule.
This field indicates the value specified for the Service Type
Field Match (IP DSCP, IP Precedence, or IP TOS).
show access-lists interface <slot/port> in
Privileged EXEC
Type of access list (IP or MAC).
Access List name for a MAC access list or the numeric iden-
tifier for an IP access list.
An optional sequence number may be specified to indicate
the order of this access list relative to other access lists
already assigned to this interface and direction. A lower num-
ber indicates higher precedence order. If a sequence number
is already in use for this interface and direction, the specified
access list replaces the currently attached access list using
that sequence number. If the sequence number is not speci-
fied by the user, a sequence number that is one greater than
the highest sequence number currently in use for this inter-
face and direction is used. Valid range is (1 to 4294967295).
v1.0, March 2006
14-35