Spanning-Tree Port Mode All; Stp Show Commands; Show Spanning-Tree - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
5.1.15.1 no spanning-tree port mode
This command sets the Administrative Switch Port State for this port to disabled.
Format
Mode

5.1.16 spanning-tree port mode all

This command sets the Administrative Switch Port State for all ports to enabled.
Default
Format
Mode
5.1.16.1 no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
Format
Mode

5.2 STP Show Commands

This section describes the commands you use to view information about STP
configuration and status.

5.2.1 show spanning-tree

This command displays spanning tree settings for the common and internal spanning tree,
when the optional parameter "brief" is not included in the command. The following details
are displayed.
Format
Modes
Bridge Priority
Bridge Identifier
Spanning Tree Protocol Commands
no spanning-tree port mode
Interface Config
disabled
spanning-tree port mode all
Global Config
no spanning-tree port mode all
Global Config
show spanning-tree <brief>
Privileged EXEC
User EXEC
Specifies the bridge priority for the Common and Internal
Spanning tree (CST). The value lies between 0 and 61440. It
is displayed in multiples of 4096.
The bridge identifier for the CST. It is made up using the
bridge priority and the base MAC address of the bridge.
v1.0, March 2006
5-9