NETGEAR ProSafe GSM7212 Cli Reference Manual page 166

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
If you use the optional
to use when connecting to the configured RADIUS server. The
- 65535, with 1812 being the default value.
Note: To re-configure a RADIUS authentication server to use the default UDP
If you use the
RADIUS accounting server. You can only configure one accounting server. If an
accounting server is currently configured, use the "no" form of the command to remove it
from the configuration. The IP address you specify must match that of a previously
configured accounting server.
If you use the optional
when connecting to the RADIUS accounting server. If a
the accounting server, the new
must be a value in the range 1 - 65535, with 1813 being the default.
<port>
Note: To re-configure a RADIUS accounting server to use the default UDP
Format
Mode
11.2.2.1 no radius server host
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured RADIUS
authentication server is removed from the configuration. Similarly, if the 'acct' token is
used, the previously configured RADIUS accounting server is removed from the
configuration. The
configured RADIUS authentication / accounting server.
Format
Mode
11-14
parameter, the command configures the UDP port number
<port>
, set the
<port> <port>
parameter, the command configures the IP address to use for the
<acct>
parameter, the command configures the UDP port to use
<port>
<port>
, set the
<port> <port>
radius server host {auth | acct} <ipaddr> [<port>]
Global Config
parameter must match the IP address of the previously
<ipaddr>
no radius server host {auth | acct} <ipaddress>
Global Config
v1.0, March 2006
parameter to 1812.
<port>
replaces the previously configured
parameter to 1813.
Port-Based Access and Authentication Commands
number range is 1
<port>
is already configured for
. The
<port>