Radius Commands; Radius Accounting Mode; Radius Server Host - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
User
System Login
802.1x Port
Security

11.2 RADIUS Commands

This section describes the commands you use to configure the 7200 Series Managed
Switch to use a Remote Authentication Dial-In User Service (RADIUS) server on your
network for authentication and accounting.

11.2.1 radius accounting mode

Use this command to enable the RADIUS accounting function.
Default
Format
Mode
11.2.1.1 no radius accounting mode
Use this command to disable the RADIUS accounting function.
Format
Mode

11.2.2 radius server host

Use this command to configure the RADIUS authentication and accounting server. If you
use the
<auth>
RADIUS authentication server. You can configure up to 3 servers per RADIUS client. If
the maximum number of configured servers is reached, the command fails until you
remove one of the servers by issuing the "no" form of the command.
Port-Based Access and Authentication Commands
Lists every user that has an authentication login list assigned.
Displays the authentication login list assigned to the user for
system login.
Displays the authentication login list assigned to the user for
802.1x port security.
disabled
radius accounting mode
Global Config
no radius accounting mode
Global Config
parameter, the command configures the IP address to use to connect to a
v1.0, March 2006
11-13