Dot1X Max-Req; Dot1X Port-Control - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

11.1.7 dot1x max-req

This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the
supplicant. The
Default
Format
Mode
11.1.7.1 no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the
supplicant.
Format
Mode

11.1.8 dot1x port-control

This command sets the authentication mode to be used on the specified port. The control
mode may be one of the following.
force-unauthorized: The authenticator PAE unconditionally sets the controlled port to
unauthorized.
force-authorized: The authenticator PAE unconditionally sets the controlled port to
authorized.
auto: The authenticator PAE sets the controlled port mode to reflect the outcome of the
authentication exchanges between the supplicant, authenticator and the authentication
server.
Default
Format
Mode
11.1.8.1 no dot1x port-control
This command sets the authentication mode to be used on the specified port to 'auto'.
Format
11-4
value must be in the range 1 - 10.
<count>
2
dot1x max-req <count>
Interface Config
no dot1x max-req
Interface Config
auto
dot1x port-control {force-unauthorized | force-
authorized | auto}
Interface Config
no dot1x port-control
v1.0, March 2006
Port-Based Access and Authentication Commands