Table of Contents
Advertisement
NOTE:
Some local regulations require
the tare weight to be read from
the scale. If so, don't use the
keyed tares feature.
NOTE:
Select OFF to disable the truck
in/out modes.
Selecting a mode
To select a truck in/out mode (as in diagram below), move setup switch
SW1 to the CONFIG position (see Setup Mode on page 5-1 ). Then,
press TIME/DATE once to drop to the next level. Press CLEAR
several times until the display reads 200TARE. Then, press TIME/
DATE again and use CLEAR to scroll to the desired mode. Finally,
press DISP TARE to lock in your selection move the setup switch back
to its normal position.
CONFIG
200TARE
OFF
MODE 1
Using the truck in/out modes
All the truck in/out modes let you quickly search the memory for a
specific ID number. To do this, key in the ID number and press DISP
TARE. If the number is in memory, it remains on the display. Other-
wise, the indicator displays NO ID or another number. Use ENTER to
toggle between the ID number and tare weight. To delete the displayed
ID number, press CLEAR twice.
To scroll through all the stored ID numbers, key in any number and
press DISP TARE. Then, each time you press DISP TARE, the next
number appears on the display.
To print all the stored ID numbers and their associated tare weights,
press PRINT when an ID number is on the screen.
Modes 1 and 2
In these two modes, the indicator erases truck ID numbers and tare
weights from memory after the transaction.
1. The truck moves onto the scale for weigh-in.
2. If keyed tares are enabled (Mode 1), key in the desired tare weight
and press TARE.
3. Key in an ID number (up to 7 digits) and press NEW ID. This
information remains in memory until the weigh-out ticket is printed.
4. The indicator prints the following weigh-in ticket for the driver:
ID. NO. 304812
GROSS 15000. LB STORED
5/4/1994 10:24 AM
5. The loaded truck moves onto the scale for weigh-out.
MODE 2
MODE 3
MODE 4
MODE 5
MODE 6
Operating modes
5-3
Advertisement
Table of Contents
