Table of Contents
Advertisement
SET
POINT
CLEAR
Table 1-4. (continued)
Set Point
Press to access the current setpoint values. When you first press this key,
the display shows "SP 1" for two seconds, then switches to show the
setpoint value. Each time you press SET POINT, the next setpoint
(SP 2, SP 3, etc.) appears.
You can change the setpoint value by keying in a number and pressing
ENTER. To turn off a setpoint, press CLEAR. The message "OFF"
appears on the display for disabled setpoints. Note: If you turn off a
setpoint while in the setup mode, you cannot reactivate it from the front
panel. You must return to the setup mode to reactivate it.
If you make an error when keying in a value, press CLEAR to erase
individual digits. To return to the normal weighing mode, press G/N or
wait for the display to switch back.
You can use the SET POINT key to view or change PREACT values
from the front panel during the normal operating mode (see Section 7,
Setpoints and Batch Processing, for more information).
If you wish to customize the prompts given while using SET POINT,
you can define up to 10 unique names. See Section 7, Setpoints and
Batch Processing, Setpoint Mnemonics, for more information.
Clear
Erases digits entered from the keyboard or clears special function values.
In the SETPOINT function, CLEAR disables setpoints or erases
individual digits.
In the DISP ACCUM function, CLEAR erases the value in the
accumulator.
In the DISP TARE function (normal weighing mode) with the current
tare value displayed, pressing CLEAR causes the following prompt to
appear: "CLR TR?" Pressing CLEAR a second time clears the tare
register.
In the DISP TARE function (Truck In/Out mode), CLEAR erases truck
IDs, as well as tare values.
Annunciator lights
The annunciator lights provide status information about the indicator.
Lb
Kg
ROC
Accum
These annunciator lights
are on the left side of the
display. See UNITS,
DISP ROC, and DISP
ACCUM in Table 1-4 for
more information.
Scale 1
Scale 2
Scale 3
Scale 4
These annunciator lights
are on the right side of
the display. See SCALE #
(or BASE #) in Table 1-4
for more information.
Introduction
1-7
Advertisement
Table of Contents
