Recipe Storage Option - Rice Lake IQ plus 800 Installation & Operation Manual

RECIPE STORAGE OPTION

This option provides nine "stored" recipes and one "working" recipe. Each
recipe has 16 setpoints. You can configure all nine working recipies from
the "SETPNTS" configuration submenu or by using EDP commands. Also,
you can copy a stored recipe into the currently running "working" recipe
from the front panel or with EDP commands. Then, you can use the
SETPOINT key to modify the working recipe without affecting the stored
recipe. Also, by using an EDP command, you can save the working recipe as
a stored recipe.
To copy a stored recipe into the working recipe location:
Enter a number corresponding to one of the stored recipes and press
NEW ID. The indicator prompts "NEW REC" and copies the recipe into the
working recipe. Return to the normal operating mode by pressing
GROSS/NET, or waiting until the display switches back.
While in normal operating mode, you can press NEW ID to verify which
recipe was last copied to the working recipe location. The indicator responds
with "RECIP x" (where x = the recipe number). Once again, return to the
normal operating mode by pressing GROSS/NET, or waiting until the
display switches back.
To change the working recipe:
You can change the working recipe from the front panel by using the
SETPOINT key. Changes to the working recipe do not affect the stored
recipes. To undo changes to the working recipe, copy the original stored
recipe over the working recipe.
Accessing the recipes in setup mode:
In the setup mode, you access the recipes from the "SETPNTS" submenu.
There are 16 configurable setpoints for each of the nine recipes.
SETPNTS
RECIPE 1
SETPT 1
SETPT 16
Using EDP commands to modify recipes:
You can modify the working recipe by using the EDP commands listed in
the following chart. You can use these EDP commands in both the normal
operating and setup modes. You must use upper case letters for the com-
mands.
RECIPE 9
SETPT 1
BATCHNG
SETPT 16 BATCHNG
Optional features 8-33