Continuous Output Serial Data Format; Demand Output Serial Data Format; Communications - Rice Lake IQ plus 800 Installation & Operation Manual

NOTE:
If your application requires a
customized format, consult your
supplier for further details.
®
2-8 IQ plus 800/810 Installation Manual

Continuous output serial data format

When you select continuous transmission in the setup menus (SERIAL
STREAM EDP, PRN, or AUX), the IQ plus
Consolidated Controls serial data format as shown below:
<STX> <POL> <wwwwwww> <UNIT> <G/N> <S> <TERM>
ASCII 02
decimal char.
Polarity:
<Space> = Positive
<–> = Negative
Weight: 7 digits, right-justified, dummy
zeroes, decimal point with no leading zeroes
except for leading zero immediately
preceding the decimal point. Leading zeroes
transmitted as spaces.

Demand output serial data format

When you select demand mode transmission in the setup menus
(SERIAL PRNDEST
uses a data string formatted for a basic ticket printout. However, you
can use the EDP port or keypad to fully customize the ticket (see
Section 9, Appendix, for more information on custom printing formats).
This allows the IQ plus
printers, scoreboard displays, and other remote equipment.
RS-485 communications (optional)
You can configure multiple IQ plus
2-wire, multidrop RS-485 serial communications line. The expanded
serial communication option must be installed. To enable RS-485
communications, an optional chip, U24, must be installed on the CPU
board (see Section 8, Optional Features, for more information on
expanded serial communications).
G = Gross
N = Net
L = pounds
K = kilogram
T = ton
G = grains
<Space> = grams
O = ounce
EDP, PRN, or AUX), the IQ plus
®
800/810 to work with a wide variety of
®
800/810 indicators to operate on a
®
800/810 uses the
<CR> <LF>
or <CR>
Status:
<Space> = valid
I = Invalid
M = Motion
O = Over/under range
® 800/810