Table of Contents
Advertisement
Version 3.1 1 Software
for IQ plus
CONTENTS
Read This First! ....................................................................................... 1
Front Panel Keys and LEDs ...................................................................... 2
Configuration Menus ............................................................................... 2
Setpoint Processing ................................................................................. 5
Truck Modes ............................................................................................ 6
Print Formatting ...................................................................................... 6
EDP Commands ....................................................................................... 6
COMING SOON!
COMING SOON!
New Stainless Steel Enclosure
for IQ plus
®
800 Indicators
The IQ plus 800 stainless steel enclosure has been
redesigned to provide easier access to internal
components: Boards are now mounted to a backplate,
rather than to the front of the enclosure. For desktop
models, this mounting allows removal of boards while the
enclosure remains attached to the mounting bracket.
Dimensions for panel mounting remain the same as for
the old enclosure, so existing units can be replaced
without changing cutouts.
The setup switch is now accessed by removing a single
screw on the backplate. Switch position can be changed
using the same screwdriver used to remove the screw. A
guard plate surrounding the switch prevents accidental
contact with internal
components.
Perhaps best of all, the
new enclosure is almost
30% lighter than its
predecessor, making the
trip from the truck to the
installation site that much
easier.
Watch for the new IQ plus 800 enclosures to start
shipping in August 1997. See Tech Talk Volume 15 for
more information about the new enclosure.
VOLUME 14, JULY 1997
®
800/810 Indicators
This Tech Talk provides a summary of the changes
included in Version 3.11 of the IQ plus
software. Release 3.11 will begin shipping in September
1997.
Read This First!
If you are upgrading to Release 3.11 or are familiar
with prior releases of the IQ plus
please note the following changes before using the
software.
The digital output of continuous setpoints using
the TRIP parameter with InBand or OutBand
specified is reversed in this release. Existing
setpoints using these values must be redefined
for use with Release 3.11. See pages 4 and 5 for
more information about this and other setpoint
processing changes.
When the indicator is placed in setup mode:
• Analog outputs are set off (0 VDC or 4 mA)
• Batching stops automatically
When the indicator is returned to operating mode,
the interrupted batch must be manually restarted.
The BATSTRT digital input no longer requires an
active BATRUN digital input to start and run a
batch sequence. If no digital input is assigned to
BATRUN, batching proceeds as if BATRUN were
always on. See page 5 for more information.
®
800/810 indicator
Warning
!
®
800/810 software,
Advertisement
Table of Contents
