Table of Contents
Advertisement
9-20
IQ plus 800/810 Installation Manual
SOFTWARE REVISION HISTORY
Version 1.0
This version was the original release.
Version 1.1 - 1.4
No new features were added; these revisions provided minor operating
refinements to the original release.
Version 2.0
Accumulators retain their totals when leaving the SETUP mode, rather then
automatically zeroing.
The 100 update per second function (1 FAST) is enabled in the CHANS
parameter of the SET ALG menu.
When batching, the net or gross display mode reflects the type (Gross / Net)
of the present batch step, and the scale number illuminators reflect the
source scale selected for that batch step.
A tare value of zero can be entered.
Setpoint values can be changed, or setpoints can be turned on or off with
front panel keystrokes while in the normal operating mode.
Version 2.1
Auto jog now references the first preceding weight setpoint (net, gross, or
relative) rather than just the first preceding setpoint. This allows conditional
setpoints like WAITSS, DELAY, PAUSE, etc. to be inserted directly before
the Autojog setpoint.
Continuous setpoints reflecting a scale condition, such as COZ,
INMOTION, INRANGE, -GROSS, -NET, and BATCHPR can now have a
source scale associated with them, rather than be forced to use the source
currently on the display.
Version 2.2
Unreleased.
Version 2.3
When using RS-485 mode, a carriage return has been added after the last
character (ETX) in the response to purge the receive buffers of all IQ plus
800/810's on the bus.
When using multiple scales, and in the TOTAL display mode, the unit will
not blank when one scale goes below GROSS ZERO, but will display the
positive total of all scales. The unit will blank, however, if one scale goes
into an underrange condition.
The following parameters can be changed "on the fly" by keying in the
correct EDP commands without the need to enter the SETUP mode:
BARGRF, BARBAND.
(continued)
Advertisement
Table of Contents
