Rice Lake IQ plus 800 Installation & Operation Manual page 140

TECH TALK
UNITS Parameter
The UNITS parameter allows units identifiers to be
customized. Default identifiers (LB-KG-OZ-TN-GR-G) can
be changed using the procedure described under the P
FORMT menu. Once changed, the custom units identifiers
appear as selections for the UNITS subparameters on the
FORMAT menu, PRIMARY and SECNDRY parameters.
Modified units identifiers can be from one to seven
characters long and use both upper and lower case
letters. The maximum length allowed for the entire identifier
string (including all units identifiers and the dashes used
as separator characters) is 30 characters.
NOTE: Displayed unit identifiers are shown in upper-
case only; printed unit identifiers show both upper and
lower case letters.
SPNAME Parameter
The SPNAME parameter allows setpoint names to be
modified at the front panel. The function of this parameter
is identical to the SPNAME#x EDP command. Use the
procedure described under the P FORMT menu to edit
setpoint names.
CONFIG XXXXXXX SET ALG FORMAT
EDP PRINTER
CONFIG XXXXXXX SET ALG FORMAT
SETPNTS SERIAL P FORMT XXXXXXX
AUX STREAM ABSTRM
OFF OFF
EDP EDP
PRN PRN
AUX AUX
Figure 4. SERIAL Menu (partial)
SETPNTS SERIAL P FORMT XXXXXXX
Figure 5. DIGIN Menu
A TECHNICAL PRODUCT PUBLICATION
SERIAL Menu
An optional parameter, ABSTRM, is added between the
STREAM and PRNDEST parameters to allow selection of
the port used for streaming to the Remote I/O Interface
(see Figure 4, below). ABSTRM is only shown if the A/B
option is enabled (FEATURE parameter on the CONFIG
menu).
P FORMT Menu
The P FORMT menu is changed to allow character editing
at the first level (see Figure 9 on page 8). The procedure
shown in Figure 9 is used for all parameters that allow
editing of alphanumeric character strings.
DIGIN Menu
The default values for DIGIN 1 and DIGIN 2 are changed
for Release 3.11 as shown in Figure 5, below.
Also, the BATSTRT digital input no longer requires an
active BATRUN digital input to start and run a batch
sequence (see BATSTRT DIGIN Dependency on BATRUN
Removed on page 5). For applications that do not require
the capability to stop or reset the batch, batching can be
started using a single digital input.
DIG IN ALG OUT XXXXXXX BAR GRF XXXXXXX
PRNDEST
EDP
PRN
AUX
ABSTRM shown only if A/B FEATURE enabled on CONFIG menu
DIG IN ALG OUT XXXXXXX BAR GRF XXXXXXX
DIGIN 1 DIGIN 2 DIGIN 3
BATRUN
BATSTRT
BATPAUS BATSTRT
ACCUM BATPAUS
CLR CN ACCUM NT/GRS
OFF CLR CN
ZERO
OFF DSPTARE
TARE ZERO
NT/GRS
TARE BATRUN
UNITS
NT/GRS BATSTRT
DSPTARE UNITS BATPAUS
PRINT ACCUM
DSPTARE
CLR CN
BATRUN
PRINT
4
CALIBRT VERSION XXXXXXX
CALIBRT VERSION XXXXXXX
OFF
ZERO
TARE
UNITS
PRINT