Table of Contents
Advertisement
Figure 8-29. Attaching Panel
Mount Brackets to IQ plus 800
Figure 8-30. Installing IQ plus
800 into Panel Mount
8-28
IQ plus 800/810 Installation Manual
IQ PLUS 800 PANEL MOUNT KIT (OPTIONAL)
The IQ plus 800 Panel Mount Kit contains two brackets, six stainless steel
screws, and a 4' length of gasket.
1.
Unplug the AC power cord before beginning.
2.
Using a template with a cutout 9-7/8" W by 7-7/16" H, transfer the
cutout outline to the panel. Cut out the panel.
3.
Attach the gasket to the edge of the cutout on the front of the panel.
4.
If the tilt stand has been attached, remove it from the indicator and
discard the large thumbscrews which held the tilt stand to the indicator.
Insert the IQ plus 800 completely into the panel cutout until the front lip
of the indicator contacts the gasket.
5.
Attach the angle brackets to the threaded holes on the sides of the
indicator case using the 1/4-20 X 3/8" screws provided.
1/4-20 X 3/8 Machine Screw
6.
Use the four 10-32 X 1 3/4" stainless steel screws to hold the indicator's
front lip snugly against the gasket so a good seal is achieved.
7.
Reattach cables to indicator and power the unit up.
Indicator Case
Panel Mount Bracket
Advertisement
Table of Contents
