Assigning The Names To Setpoints - Rice Lake IQ plus 800 Installation & Operation Manual

NOTE:
The defined name can be printed
on the setpoint print ticket by
including the <NA> command
in the SPFMT print format
string.
®
7-6 IQ plus 800/810 Installation Manual
Table 7-3.
Setpoint name defaults
Name... Default...
SPNAME#0 INGRED1
SPNAME#1 INGRED2
SPNAME#2 INGRED3
SPNAME#3 INGRED4
SPNAME#4 INGRED5
SPNAME#5 INGRED6
SPNAME#6 INGRED7
SPNAME#7 INGRED8
SPNAME#8 INGRED9
SPNAME#9 INGRD10

Assigning the names to setpoints

The setpoint parameter NAME allows you to assign names to setpoints.
NAME can be set to the SPNAME number 0,1,2,...9, as shown above.
The NAME parameter defaults to "NONE", meaning that no name is
assigned to the setpoint.
The setting can be changed in the SETUP menu, or you can use the
NAME serial command via the EDP port. An example of assigning
names to setpoints is given as follows:
Suppose you define the following names —
SPNAME#0=CORN
SPNAME#1=PEAS
SPNAME#2=CARROTS
SPNAME#3=BEANS
Then, you assign these names to setpoints —
SETPOINT=1
NAME=1
SETPOINT=2
NAME=3
When you press the SET POINT key to access setpoint #1, the indica-
tor will read "PEAS". When you press the SET POINT key to access
setpoint #3, the indicator will read "BEANS".