Connecting To The Ipc - YASKAWA YRC1000 Startup Manual

VERSION 5.3.0

CONNECTING TO THE IPC

Forge/OS must communicate with the Yaskawa controller. This section will help you connect the IPC device and
YRC1000 using a Cat5e STP Ethernet cable.
Find a Cat5e STP Ethernet cable long enough to reach from the IPC to inside the Yaskawa controller.
1
Remove another cable covering plate. Make a hole on the plate for the Ethernet cable.
2
Tip: Install a cable gland for strain relief.
Feed the Ethernet cable through the plate. Refer to Yaskawa's YRC1000 Instructions for proper cable sealing and
3
routing.
Mount the plate in place.
4
© 2022 COPYRIGHT READY Robotics ALL RIGHTS RESERVED
21