Advertisement
Ⅳ . 縫紉機運轉前
1. 加油
(1) 向加油罐裡加油
把 New Defrix Oil No.1 機油加到 MAX 記
●
號的位置①。
(2) 旋梭油量的調整
放鬆油量調節固定螺母 ②，然後用油量調
●
整螺絲③進行調節。
調節旋梭的油量時，鎖緊油量調節螺絲③
●
則油量減少。
油量調節後，請用固定螺母②進行固定。
●
新裝縫紉機或較長時間沒有用過的縫紉
●
機，使用之前請取下梭殼，在旋梭邊槽加
2 ～ 3 滴機油。另外，向下軸前金屬部件
④的加油孔⑤加幾滴油，把油浸潤到裡面
的毛氈裡。
注意
CAUTION
④
P12
為了防止突然起動造成人身事故，請關掉電源，確認馬達確實停止轉動後
再進行操作。
To protect against possible personal injury due to abrupt start of the
machine, be sure to start the following work after turning the power off
and ascertaining that the motor is at rest.
⑤
①
Ⅳ .PREPARATION BEFORE
OPERATION
1.Lubrioation
(1) Lubricating oil to oiling tank
Fill the oiling tank with New Defrix Oil No.1
●
up to the level indicated by "MAX" ① .
(2) Adjusting the lubrication for the sewing
hook
Adjust the amount of oil supplied to the
●
sewing hook by loosening lock nut ② and
turning oil amount adjusting screw ③ .
Amount of supplied oil is reduced when
●
turning the screws ③ clockwise.
Fix the screw with lock nut ② after
●
adjusting the lubrication for the sewing
hook.
When you first operate your sewing
●
machine after set-up or after an extended
period of disuse, remove the bobbin case
and apply a few drops of oil to the hook
race. In addition, apply a few drops oil
from oiling hole ⑤ in hook driving shaft
front metal ④ to soak the inside felt in oil.
油量調節部詳細圖
Detailed diagram of oil amount adjusting section
②③
供油管 Oil pipe
③
②
少 Decrease
供油量 Oil amount
多 Increase
Advertisement
