Advertisement
•下縫次數
設定下縫的次數
S34
•Number of times of basting
This item sets number of times
of basting.
•下縫間隔
設定進行下縫時的縫製間隔
S35
•Basting pitch
This item sets pitch at the time of performing basting.
•下縫捲入長度
設定進行下縫時的上線捲入縫製長度
S36
•Rolling length of basting
This item sets rolling length of needle thread when performing basting.
•下縫捲入間隔
設定進行下縫時的上線捲入縫製間隔
S37
•Rolling pitch of basting
This item sets rolling pitch of needle thread when performing basting.
•下縫捲入寬度
設定進行下縫時的上線捲入縫製寬度
S38
•Rolling width of basting
This item sets rolling width of needle thread when performing basting.
•下縫落針前後修正
進行 2 迴圈以上的下縫時，設定落針處的前後移動量
S39
•Lengthwise compensation of needle entry of basting
This item sets the amount to move needle entry position back and forth
when performing basting more than two cycles.
•下縫落針左右修正
進行 2 迴圈以上的下縫時，設定落針處的左右移動量
S40
•Crosswise compensation of needle entry of basting
This item sets the amount to move needle entry position to the right or
left when performing basting more than two cycles.
•下縫左側位置修正
設定把下縫的縫製基準位置從左包縫的中心向左右的移動量
S41
•Compensation of left side position of basting
This item sets the amount to move the sewing reference position of basting
from the center of left overedging to the right or left.
S42
•設定下縫速度
設定下縫的速度
S44
•Speed setting of basting
This item sets speed of basting.
•左平行部張力
設定左平行部的上線張力
S51
•Left parallel section tension
This item sets needle thread tension at left parallel section.
•右平行部張力
設定右平行部的上線張力
S52
•Right parallel section tension
This item sets needle thread tension at right parallel section.
•左平行部張力（雙重縫的第 1 迴圈）
雙重縫時，設定第 1 迴圈的左平行部上線張力
S53
•Left parallel section tension (1st cycle of double stitching)
This item sets needle thread tension at left parallel section of 1st cycle
at the time of double stitching.
：有下縫（設定次數）
：無下縫
：With basting
：Without basting
(Setting of number
of times)
Introduction
1次
0∼9
–
1 time
1.0∼5.0
0.1mm
*3
2.0∼20.0
0.1mm
*3
0.2∼5.0
0.1mm
*3
0.0∼4.0
0.1mm
*3
0.0∼2.5
0.1mm
*2, *3
0.0∼1.0
0.1mm
*3
-2.0∼2.0
0.1mm
*2, *3
-2.0∼2.0
0.1mm
*2, *3
400∼4200
100sti/min
*3
0∼200
1
–
0∼200
1
*2
0∼200
1
*2, *3
P41
Advertisement
