Advertisement
⑵迴圈縫資料的編輯方法
1) 設定為輸入模式
液晶顯示①的背景照明為藍色的輸入模式
時，可以輸入迴圈縫資料。背景照明為綠
色的縫製模式時，請按準備鍵②
為輸入模式
2) 叫出編輯迴圈縫資料 NO.
按圖案 NO. 鍵⑦
面之後， 現在被選擇的圖案 NO.B 閃亮顯
示。按項目選擇鍵⑩
的圖案順次地變換顯示，最後的圖案 NO.
以後，顯示被登記的迴圈縫數據 NO.、連
續縫資料 NO.。這裡請選擇想縫製的迴圈
縫 NO.。
3) 把迴圈縫資料設定為編輯狀態
按資料鍵⑧
輯中顯示 C，最初縫製的圖案 NO.D 閃亮
顯示。此狀態可以編輯資料。
4) 選擇編輯要點
按項目選擇鍵⑩
順次移動閃亮。論據最後進入編輯要點之
後，顯示出追加指示圖示
5) 變更選擇的編輯要點的資料
按數據變更鍵
輯要點的資料。 被登記的圖案 NO. 被顯
示出來，可以進行選擇。另外，按復位鍵
③
之後，可以刪除編輯要點的圖案資
料。 請反覆步驟 4)、步驟 5) 進行資料編
輯。
P56
變換
，叫出圖案樣選擇畫
之後，被登記
之後，變為迴圈縫資料編
之後，編輯要點
。
之後，可以變更編
(2) Method of editing cycle data
1) Set the mode to input mode.
When the back-light of LCD display ①
shows the input mode in blue color, it is
possible to input the cycle data. When
the back-light is the sewing mode in
green color, press READY key ②
change over to the input mode.
2) Call cycle data No. to edit.
Press PATTERN No. key ⑦
call pattern selection screen, and
pattern No. B which is selected at
present flashes on and off. Press
ITEM SELECTION key ⑩
patterns which have been registered are
changed over and displayed in order.
Cycle data No. and continuous stitching
data No. which have been registered
after the last registered pattern No. are
displayed. Here, select the cycle data
No. which you desire to sew.
3) Set cycle data to editing status.
Press DATA key ⑧
editing display C appears. Pattern No. D
which is sewn first flashes on and off. In
this state, it is possible to edit the data.
4) Select editing point.
Press ITEM SELECTION key ⑩
, and editing point moves in order
and flashes on and off. When moving
the editing point up to the last data,
additional indication pictograph
displayed.
5) Change data of selected editing point.
Press DATA CHANGE key
data of editing point can be changed.
Pattern No. which has been registered
is displayed and it is possible to select.
In addition, press RESET key ③
and the pattern data of editing point
can be deleted.Repeat steps 4) and 5)
to perform editing data.
to
to
, and
, and cycle data
is
and
,
Advertisement
