Advertisement
6. 變更上線張力
有關上線張力的資料，可以用縫製模式進行
設定，也可以邊試縫邊變更。
(1) 叫出平行部張力設定資料
按平行部張力鍵
料編輯畫面 A。
(2) 變更平行部張力
按數據變更鍵
可以進行變更。縫製和設定值的關係如
下圖所示，請參考設定。
(3) 叫出加固部張力設定資料
按加固部張力鍵
編輯畫面 C。
(4) 變更加固部張力
按數據變更鍵
可以進行變更。縫製效果和設定值的關
係如下表所示，因此請參考下表進行設
定。
※ 平行部和加固部以外的張力，請參照 11. 變
更縫製數據 和 20. 記憶體開關資料的變更方
法 的有關內容。
，顯示出縫製資
，增減設立值 B
，顯示出縫製資料
，增減設立值 D
B
D
6. Changing needle thread tension
Needle thread tension can be changed
while performing trial sewing since the
data related to the needle thread tension
can be set by the sewing mode as well.
(1) Call thread tension at parallel section
setting data.
Press THREAD TENSION AT PARALLEL
SECTION key
edit screen A is displayed.
(2) Change thread tension at parallel
section.Press DATA CHANGE key
, and set value B goes up or
comes down and the thread tension can
be changed. The relation between the
finish of sewing and the set value is as
shown in the illustration below. Set the
value referring to the illustration.
(3) Call thread tension at bar-tacking
section setting data.
Press THREAD TENSION OF BAR-
TACKING SECTION key
sewing data edit screen C is displayed.
(4) Changing the needle thread tension at
bar-tacking section
Press DATA CHANGE key
, and set value D goes up or comes
down and the thread trension can be
changed. The relation between the
finish of sewing and the set value is
as shown in table below. Set the value
referring to the table.
※ For the tension other than that at parallel
section and bar-tacking section, refer to
11. Changing sewing data and 20. Method
of changinf memory switch data.
A
1).2)
C
3).4)
Introduction
, and sewing data
, and
P25
Advertisement
