Advertisement
11. 暫停開關的固定
出貨時，暫停開關為 A 的狀態，請放鬆固
定螺絲①，變更為 B 狀態，然後用附屬的
固定螺絲② 和固定螺絲① 固定好。
12. 導線桿
請把線導向桿朝向正面插到 2 個的橫孔。
13. 線架裝置的安裝
⑴安裝線架裝置，把它安裝到機台右上的
孔裡。
⑵鎖緊固定螺母①，不讓線架裝置鬆動。
⑶如果頂部可以配線時，請把電源線從線
架桿② 中穿過去。
11.Fixing the temporary stop switch
①
A
12.Thread guide rod
導線桿
Thread guide rod
13.Installing the thread stand
②
①
Introduction
The temporary stop switch has been in the
state as shown in figure A at the time of
delivery.Loosen setscrew ① and set the
switch in the state as shown in figure B,
and fix it with setscrew ① together with
setscrew ② supplied with the machine.
①
②
B
Securely fit the thread guide rod so that
two side holes in the thread guide rod
face the thread guide.
⑴ Assemble the thread stand, and set it
in the hole in the top right corner of the
machine table.
⑵ Tighten locknut ① to fix the thread
stand.
⑶ When ceiling wiring is possible, pass
the power cable through spool rest rod
② .
P11
Advertisement
