Advertisement
14. 複製縫製圖案
可以把已登記的圖案 NO. 的資料複製到沒
有使用的 NO.。因為圖案設定為禁止重寫
複製，所以需要重寫時，請先把圖案消去
後再進行複製。
1) 設定為輸入模式
液晶顯示①的背景照明為青色的輸入模
式時，可以複製。背景照明為綠色的縫
製模式時， 請按準備鍵②
入模式。
2) 選擇要複製的原圖案 NO.
在圖案選擇畫面，選擇複製的原圖案
NO.。 →請參照 5. 選擇圖案 的內容。
編制新圖案資料時，複製初期值圖案的
話使用起來非常便利。→請參照 10. 使
用初期值模式 的內容。
3) 叫出複製畫面
按複製鍵
A。
4) 選擇複製位置的圖案 NO.
沒有使用的圖案 No.B 閃亮顯示，所以
按資料變更鍵
No.。如果想消去圖案時，請選擇垃圾
箱
。
5) 開始複製
按準備鍵②
秒鐘後，在編制圖案 No. 被選擇的狀
態，返回輸入畫面。按復位鍵③
不複製返回原來的畫面。
※ 迴圈資料、連續縫製資料也可以用同樣的方
法進行複製。
P44
變換為輸
之後，顯示出複製畫面
，選擇想複製的
之後開始複製，複製 2
，
14. Copying sewing pattern
Data of pattern No. which has been
already registered can be copied to
pattern No. which has not been used.
Overwriting copy of the pattern is
prohibited. When you desire to overwrite,
perform it after erasing the pattern once.
1) Set the mode to input mode.
When the back-light of LCD
display ① shows the input mode in
blue color, it is possible to copy. When
the back-light shows the sewing mode
in green color, press READY key ②
to change over to the input mode.
2) Select pattern No. of copy source.
Select pattern No. of copy source from
the pattern selection screen. → Refer
to 5. Performing pattern selection
When creating pattern data quite
newly. it is convenient to copy the
initial value pattern. → Refer to 10.
Using initial value pattern.
3) Call copy screen.
Press COPY key
screen A is displayed.
4) Select pattern No. of copy destination.
Pattern No. B which is not used flashes
on and off in the display. Press DATA
CHANGE key
the No. you desire to copy.When you
desire to erase the pattern, select the
garbage can
5) Start copying.
Press READY key ②
copying. After two seconds, the pattern
No. which is created by copying
returns to the input screen in the state
of being selected.
Press RESET key ③
screen returns to the former one
without copying.
※ In addition, cycle data and continuous
stitching data can be copied by the same
method.
, and copy
, and select
.
to start
, and the
Advertisement
