Advertisement
2. 縫紉機的基本操作
1) 打開電源開關
首先，請確認被設定的壓腳類型 A 和實際
安裝的壓腳類型是否一樣。確認和設定方
法請參閱 4. 輸入壓腳類型 。
2) 選擇想縫製的圖案 No.
打開電源後，現在被選擇的圖案 No.B 閃
亮。想變更時，按選擇項目鍵 ⑩
選擇想縫製的 No.。購買時，在 11. 變更
縫製數據 時裡記載的圖案 No.1 ～ 10 均
已被登記，因此可以從中選擇。（圖案沒
有被登記的號碼不顯示。）
3) 進入可以縫製狀態
按準備鍵②
之後，液晶顯示①的背
景燈由藍色變為綠色，成為可以縫製的狀
態。
4) 開始縫製
把縫製物放到壓腳部，踩踏板，縫紉機開
始縫製購買時，設定為雙踏板規格，踏板
操作方法可以從 3 種中進行選擇。請選擇
喜歡的操作方法使用。 → 3. 踏板的操作
方法
2. Basic operation of the sewing machine
1)Turn ON the power switch.
2) Select the pattern No. you desire to sew.
3) Set the sewing machine to sewing
4) Start sewing.
②
B
Introduction
First, check that presser type A which
has been set is the same as that of the
presser actually mounted. For checking
and setting procedures, refer to 4.
Inputting the presser type.
When the power is turned ON, the
pattern No. B which is selected at
present flashes on and off. When
you desire to change it, press ITEM
SELECTION key ⑩
the No. you desire to sew. When you
purchase the sewing machine, pattern
No. 1 to 10 described in 11.Changing
sewing data have been registered.
Select the pattern No. you sesire to sew
from among these numbers. (The No.
with which the pattern has not been
registered is not displayed.)
possible state.
Press READY key ②
light of LCD display ① changes from
blue color to green color, and sewing is
possible.
Set the sewing product to the presser
portion, and operate the pedal to
start the sewing machine, and sewing
starts. When you purchase the sewing
machine, 2-pedal type has been set.
However, pedal operating procedure
can be selected from among three
ones. Select the operating procedure
you desire and use the sewing
machine. → 3. How to use the pedal
①
A
⑩
and select
and the back-
P19
Advertisement
