Advertisement
錯誤代碼
Error code
•底線切線馬達原點檢索異常
原點檢索動作時，原點感測器信號沒有被輸入時
E911
•Bobbin thread trimmer motor origin retrieval error
When origin sensor signal is not inputted at the time of
origin retrieval motion.
•操作盤 主 CPU 間通訊異常
資料通訊時發生異常後
E915
•Abnormality of communication between operation panel
and main CPU
When abnormality occurs in communication.
•主 CPU 主軸
資料通訊時發生異常後
E916
•Abnormality of communication between main CPU and
main shaft CPU
When abnormality occurs in communication.
•主控制電路板用熱敏電阻溫度異常
主控制電路板的熱敏電阻達 85℃以上時
•Abnormality of temperature of heat sink for main control
E918
p.c.b.
When temperature of heat sink of main control p.c.b. is
85℃ or more.
•主控制電路板的 EEP-ROM 不良
EEP-ROM 不能寫入時
E943
•Defectiveness of EEP-ROM of main control p.c.b
When data writing to EEP-ROM is not performed.
•機頭部連接電路板 EEP-ROM 不能寫入
EEP-ROM 不能寫入時
E946
•Defectiveness of writing to EEP-ROM of head relay p.c.b.
When data writing to EEP-ROM is not performed.
•布切刀不能返回原位時
布切刀在規定時間後不能返回原位時
切布刀上升時（待機時）感測器不動作時。
•When cloth cutting knife does not return
E999
When cloth cutting knife does not return after the lapse of
predetermined time.
When sensor is not turned ON while cloth cutting knife is
raising (at the time of waiting).
P80
錯誤內容
Description
CPU 間通訊異常
復位方法
How to recover
Place of recovery
電源 OFF
Turn OFF the power.
電源 OFF
Turn OFF the power.
電源 OFF
Turn OFF the power.
電源 OFF
Turn OFF the power.
電源 OFF
Turn OFF the power.
電源 OFF
Turn OFF the power.
電源 OFF
Turn OFF the power.
復位地點
Advertisement
