Advertisement
縫紉前的準備
機針的安裝方法
安裝機針時，請切斷電源。
當誤按動開關時，縫紉機動作會導致人群
受傷。
1. 轉動縫紉機上輪，將針桿移動到最高位
置。
2. 鬆開螺釘（1）。
3. 將機針（2）上的長槽（3）朝著內側，
筆直插到底並擰緊止動螺釘（1）。
梭芯的裝拆方法
取出梭芯時，請切斷電源。
當誤按動開關時，縫紉機動作會導致人員
受傷。
①掛鉤式
1. 將推板（1）左右分開。
2. 將旋鎖的捏手（2）提起之後，取出
梭芯（3）。
②梭芯套式
1. 將推板（1）左右分開。
2. 將旋鎖的捏手（2）提起之後，取出
梭芯套（3）。
3. 取出梭芯。
①
P6
PREPARATION BEFORE SEWING
Installing the needle
Turn off the power switch before installing the needle.
The machine may operate if the treadle is depressed by istake,
which could result in injury.
1.Turn the machine pulley to move the needle
position.
2.Loosen the screws (1).
3.Insert the needle (2) straight in as it will go so that the long
groove is facing inward,and then securely tighten the screws (1).
Removing the bobbin
Turn off the power switch before removing the bobbin.
The machine may operate if the treadle is depressed by mistake,
which could result in injury.
① Latch type
1.Open the slide plates (1) by moving them to the right and left.
2.Pull the rotary hook latches (2) upward, and them remove the
bobbins (3).
② Bobbin case type
1.Open the slide plates (1) by moving them to the right and left
2.Lift up the latch (2) of the rotary hook, and then remove the
bobbin case (3).
3.Remove the bobbin.
②
bar to its hidhest
Advertisement
