Sysmac Studio Procedures; Flow Of Operations For The Sysmac Studio - Omron NX Series User Manual

8 Applicable Support Software for IO-Link Systems
8-2

Sysmac Studio Procedures

The Sysmac Studio is used to assign I/O data and set parameters in the IO-Link Master Unit.
This section describes the flow of operations when you use the Sysmac Studio. Refer to 1-6 Startup
Procedures on page 1-28 for the basic procedure for the entire IO-Link System.
8-2-1

Flow of Operations for the Sysmac Studio

The following gives the operation flow on the Sysmac Studio for each type of communications with the
controller.
Controller Communications with EtherCAT
The following describes the procedure to use an NJ/NX-series CPU Unit, an NY-series Industrial PC,
or a controller from another company as the controller.
• Using an NJ/NX-series CPU Unit or NY-series Industrial PC as the Controller
Use the Sysmac Studio to set EtherCAT PDO allocations, make NX/GX-type IO-Link Master Unit
settings, enter the programs, and make adjustments.
8-4
NX/GX-series IO-Link System User's Manual (W570)