Omron NX Series User Manual page 196

8 Applicable Support Software for IO-Link Systems
Interface
Network Address
Node Address
Unit No.
COM Port
Baud Rate
Data Length
Parity
Stop Bit
2
Make the settings that are required to connect to the CS/CJ1-series PLC and then click the OK
Button.
If the connection is successful, the Browse Network Dialog Box is displayed.
3
Set the options as necessary and then click the Refresh Button.
The PLC and the Communication Units that are mounted on it are now listed.
4
Select TCP:2 port on the PLC or TCP:2 port on the Communication Unit and click the OK But-
ton.
The Support Software goes online.
8-38
Item
Select the serial communications mode for the serial communications port on
the CS/CJ1-series PLC.
You can select Toolbus or Host Link.
Enter the network address of the connected EtherNet/IP Unit. Specify the
network address if data passes over the network at a point beyond the serial
communications port of the CS/CJ1-series PLC. Otherwise, enter 0.
Enter the node address of the connected EtherNet/IP Unit. Specify the net-
work address if data passes over the network at a point beyond the serial
communications port of the CS/CJ1-series PLC. Otherwise, enter 0.
Enter the Unit number of the connected EtherNet/IP Unit as a CPU Bus Unit.
Select the COM port of the computer that you use for communications.
Set the baud rate of the serial communications port on the CS/CJ1-series
PLC.
Set the data length for the serial communications port on the CS/CJ1-series
PLC. The data length setting is valid when the host link interface is selected.
Set the parity for the serial communications port on the CS/CJ1-series PLC.
The parity setting is valid when the host link interface is selected.
Set the stop bit for the serial communications port on the CS/CJ1-series
PLC. The stop bit setting is valid when the host link interface is selected.
Description
NX/GX-series IO-Link System User's Manual (W570)