Io-Link Master Unit Parameters - Omron NX Series User Manual

3-2

IO-Link Master Unit Parameters

This section describes the parameters for IO-Link Master Units.
Set the following parameters for each port from the IO-Link Master Unit Configuration Tool or with
communications instructions.
The settings of all of the following parameters can be backed up and restored.
For details, refer to the object list for each Master Unit.
Refer to 6-3-2 Message Communications with the IO-Link Master on page 6-8 for information on in-
structions.
Precautions for Correct Use
When you use the EtherNet/IP Coupler Unit with unit version 1.1 or earlier, you cannot use
communications instructions for the IO-Link Master Unit. Use the EtherNet/IP Coupler Unit with
unit version 1.2 or later to use a communications instruction.
Setting (= object
name)
IO-Link Device Verifi- This setting specifies
cation Setting whether to verify that
the IO-Link devices
connected to the ports
match the IO-Link devi-
ces in the IO-Link De-
vice Configuration Set-
tings when IO-Link
communications start.
You can verify the ven-
dor ID, device ID, IO-
Link revision, and serial
number of the connect-
ed IO-Link device for
each port using either
of the following two pat-
terns.
•
•
NX/GX-series IO-Link System User's Manual (W570)
Description Default
00 hex:
Do not
check.
Vendor ID + Device
ID + IO-Link revision
Vendor ID + Device
ID + Serial number +
IO-Link revision
NX-type IO-Link
Master Unit
Setting range
Index
00 to 02 hex 5001
00 hex: Do not hex
check.
01 hex: Verify the
vendor ID, device
ID, and IO-Link re-
vision.
02 hex: Verify the
vendor ID, device
ID, serial number,
and IO-Link revi-
sion.
3 Parameter Settings
GX-type IO-Link
Master Unit
Subin- Subin-
Index
dex dex
01 to 3011 01 to
04 hex hex 08 hex
3-3
3