CHAPTER 7
This chapter describes the setting procedures of the D/A converter module.
● After writing the contents of new module, parameter settings, and auto refresh settings into the CPU module, reset the
CPU module, switch STOP RUN STOP RUN, or switch OFF ON the power supply to enable the setting
contents.
● After writing the contents of switch settings into the CPU module, reset the CPU module or switch OFF ON the power
supply to enable the setting contents.
7.1
Addition of Modules
Add the model name of D/A converter modules to use on the Project.
(1) Addition procedure
Open the "New Module" window.
Project window
Module Selection
Mount Position
Title Setting
VARIOUS SETTINGS
[Intelligent Function Module]
[New Module]
Item
Module Type
Set "Analog Module".
Module Name
Select the name of the module to be connected.
Mounted Slot No.
Set the slot No. where the module is connected.
The start I/O number (hexadecimal) of the module is set according to the mounted slot
Specify start XY address
No. The start I/O number also can be set by a user.
Title
Set any title.
CHAPTER 7 VARIOUS SETTINGS
Right-click
Description
7
55