8.8.1
Initial settings of the wave output function
For the wave output function, set the following items as the initial setting. Before using the wave output function,
complete the procedures described in this section.
• Creating wave data (
• Setting parameters of the wave output function (
• Writing data to a file register (ZR) or CSV file (
• Switch setting and basic setting (
(1) Creating wave data
Create the wave data in "Create Wave Output Data" of GX Works2.
1.
Start "Create Wave Output Data".
[Tool]
2.
Select "Module Type" according to the module used.
L60DA4
L60DAVL8, L60DAIL8
● Set the correct value in "Module Type" and follow the procedure 3 or later to set "Wave pattern" and "Wave output data"
properly.
● If "Module Type" is changed after the procedure 3 or later, "Wave pattern" and "Wave output data" are completely
deleted.
96
Page 96, Section 8.8.1 (1))
[Intelligent Function Module Tool]
[Create Wave Output Data]
Module
Page 103, Section 8.8.1 (2))
Page 106, Section 8.8.1 (3))
Page 110, Section 8.8.1 (4))
[Analog Module]
Q64DAH/L60DA4
L60DAVL8/L60DAIL8
"Module Type"