Mitsubishi Electric MELSEC L Series User Manual page 209

(27)CH Wave output status monitor (Un\G1100 to Un\G1107)
This area stores the wave output status for each channel.
The value is stored only in the wave output mode. In other than the wave output mode, 0 is stored.
(28)CH1 Wave output conversion cycle monitor (L) (Un\G1108) to CH8 Wave output
conversion cycle monitor (H) (Un\G1123)
This area stores the conversion cycle of the wave output in 32-bit signed binary for each channel. The unit of the
stored value is s.
The value is stored only in the wave output mode. In other than the wave output mode, 0 is stored.
CH1 Wave output conversion cycle monitor (H) (Un\G1109)
b31
Sign bit
0: Positive (fixed)
(a) Update of the stored value
When Operating condition setting request (Y9) is turned OFF  ON  OFF, the stored value is updated.
(29)CH Wave pattern output count monitor (Un\G1124 to Un\G1131)
This area stores the output count of the wave pattern for each channel. The value is stored only in the wave
output mode. In other than the wave output mode, 0 is stored.
(a) Count of the wave pattern output
Outputting the set wave pattern once adds 1.
(b) Count range of the wave pattern output
• Count range: 0 to 32767
When the wave pattern output count is set to the unlimited repeat output, the count returns to 0 and starts from
1 again if it exceeds the count range.
(c) Reset of the stored value
In the following cases, the stored value of CH Wave pattern output count monitor (Un\G1124 to Un\G1131) is
reset.
• When Operating condition setting request (Y9) is turned OFF  ON  OFF
• When the wave output status becomes to other status from the wave output stop
Wave output status
Wave output stop
Wave output
Wave output pause
Wave output step action
b16
Data section
Common
CH1 Wave output conversion cycle monitor (L) (Un\G1108)
b15
APPX
Common
Stored value
0
1
2
3
b0
Common
207
A