Mitsubishi Electric MELSEC L Series User Manual page 55

(b) For current output
D/A
conversion
D/A
conversion
AG
*1 For wire, use the shielded twisted pair cable.
*2 If noise or ripple occurs for analog signals, connect a capacitor with the value of 0.1 to 0.47F (withstand voltage 25V or
higher) to the input terminal of an external device.
*3 Connect the shielded wire for each channel to one of the three shield terminals. Be sure to ground the FG terminal.
Also, ground the FG terminal of the power supply module.
(2) L60DAVL8
D/A
conversion
AG
*1 For wire, use the shielded twisted pair cable.
*2 If noise or ripple occurs for analog signals, connect a capacitor with the value of 0.1 to 0.47F (withstand voltage 25V or
higher) to the input terminal of an external device.
*3 Be sure to ground the shielded wire for each channel.
Also, ground the FG terminal of the power supply module.
*1 *2
CH1
I+
COM
*3
SLD
*3
Shield
CH2
I+
COM
*3
SLD
CH3
I+
COM
*3
SLD
*3
Shield
CH4
I+
COM
+24V
24VDC
24G
Filter
FG
*1 *2
V+
COM
+24V
24VDC
24G
Filter
CHAPTER 6 INSTALLATION AND WIRING
Motor drive module
or others
0 to 600
GND
Motor drive module
or others
0 to 600
GND
Motor drive module
or others
0 to 600
GND
Motor drive module
or others
0 to 600
GND
Motor drive module
or others
1k to 1M
GND
Shield
*3
6
53