Mitsubishi Electric MELSEC L Series User Manual page 206

(23)CH Wave pattern output repetition setting (Un\G1056 to Un\G1063)
This area is for setting the repeat count to output the wave pattern repeatedly. This area can be set only in the
wave output mode.
For details on the wave output function, refer to the following.
• Wave Output Function (
(a) Setting range
• Follow the setting range below.
Setting value
-1
1 to 32767
• Even though the setting value is changed in the mode other than the wave output mode, the change is not
applied.
• In the channel where a value out of the above setting range is set, an error occurs. The error code (34)
is stored in Latest error code (Un\G19), Error flag (XF) turns on, and the ERR. LED turns on. The wave
output cannot be executed.
(b) Enabling the setting
Turn OFF  ON  OFF Operating condition setting request (Y9) to enable the setting.
(c) Default value
All channels are set to 1.
(24)CH Constant for wave output conversion cycle (Un\G1064 to Un\G1071)
Set the constant to decide the conversion cycle (specify a multiple of the conversion speed). The conversion
cycle can be set with the value set in this area under the following conditions.
Conversion cycle ( s)
This area can be set only in the wave output mode.
For details on the wave output function, refer to the following.
• Wave Output Function (
(a) Setting range
• Setting range: 1 to 5000
• Even though the setting value is changed in the mode other than the wave output mode, the change is not
applied.
• In the channel where a value out of the above setting range is set, an error occurs. The error code (35)
is stored in Latest error code (Un\G19), Error flag (XF) turns on, and the ERR. LED turns on. The wave
output cannot be executed.
(b) Enabling the setting
Turn OFF  ON  OFF Operating condition setting request (Y9) to enable the setting.
(c) Default value
All channels are set to 1.
204
Page 86, Section 8.8)
The wave pattern is output in analog unlimitedly.
The wave pattern is output in analog for the counts of the setting value.
= Conversion speed
Page 86, Section 8.8)
Description
Number of channels where
D/A conversion is enabled
Common
Common
Constant for wave output
conversion cycle