Mitsubishi Electric MELSEC L Series User Manual page 113

3.
Set the "Output mode setting".
Module
L60DA4
L60DAVL8, L60DAIL8
(b) Basic setting
Change D/A conversion enable/disable setting (Un\G0) using a program or function block (FB). Register the
wave data and parameters for the wave output function first, then change D/A conversion enable/disable
setting (Un\G0).
For registration of the wave data and parameters for the wave output function, refer to the following.
• Registering the wave data and parameters of the wave output function (
Enable D/A conversion only for the channel to be used because the conversion cycle of the wave output varies
depending on the number of channels where D/A conversion are enabled.
Setting value
• "Wave output mode (conversion speed: 50s/CH)"
• "Wave output mode (conversion speed: 80s/CH)"
"Wave Output Mode"
Page 113, Section 8.8.2 (1))
CHAPTER 8 FUNCTIONS
111
8