Table of Contents
Advertisement
4. Leak Compensation (Trilogy 200, Trilogy O
If you are using an Active Flow circuit, you can turn Leak Compensation On or Off.
Enabling Leak Compensation when using the Active Flow Circuit configuration only
affects triggering and does not affect tidal volume delivery or Vte measurement.
5. Flow Cycle Sensitivity
If you set the Trigger Type to Flow Trigger, the Flow Cycle Sensitivity setting displays. You can
increase or decrease the setting from 10 to 40 percent (%) in 1% increments for Trilogy 100 and
from 10 to 90 (%) in 1% increments for Trilogy 200, Trilogy O
6. Ramp Length
The Ramp Length allows you to set the ramp time. You can disable Ramp by selecting Off, or you
can increase or decrease the Ramp Length setting from 5 to 45 minutes in 5-minute increments.
The Ramp Start Pressure setting will not display if the Ramp Length is
set to Off or if the CPAP pressure is set to 4 pressure units.
7. Ramp Start Pressure
You can increase or decrease the ramp start pressure in increments of 1 to 4 pressure units to the
CPAP pressure setting. The patient also has access to this setting, unless the ramp length is set to
Off.
Ramp Start Pressure is less than or equal to CPAP -1 pressure unit in CPAP mode.
8. Flex
You can enable or disable the Flex setting. Off disables the setting and prevents the patient from
using Flex. To enable the setting, set Flex to 1, 2, or 3. The patient also has access to this setting,
if Flex is enabled. The Flex feature is not available when using an active circuit.
•
In CPAP mode, Flex is only available when CPAP is greater than 4 pressure units.
•
In S mode, Flex is only available when EPAP is greater than or equal to 4 pressure units
and IPAP is less than or equal to 25 pressure units.
P
5-18
AGE
NOTE
NOTE
NOTE
NOTE
T
S
& T
RILOGY
ERVICE
ECHNICAL
, & Trilogy 202 Only)
2
, & Trilogy 202.
2
I
NFORMATION
1002735, V
. 05
ER
Advertisement
Table of Contents
