Summary of Contents for Respironics Tranquility Bilevel 1700
Page 1
1700-00C.QXD 10/21/99 8:38 AM Page 1 Compact Bilevel System Compact Bilevel System Model 1700 Model 1700 The Respironics Tranquility Bilevel is a medical device. Patient Operating Instructions It has been prescribed by a physician to assist breathing.
1700-00C.QXD 10/21/99 8:38 AM Page 2 Table of Contents User/Owner Responsibility Scope of this Manual Introduction Warnings and Cautions Set-up and Use Unpacking and Inspection Initial Use Routine Use 9-10 Humidifier Using Oxygen with this System 10-11 AC Fuse Traveling with your Bilevel System DC Operation Altitude Compensation Maintenance...
Page 3
1700-00C.QXD 10/21/99 8:38 AM Page 3 Glossary of Symbols Symbol Description Attention, consult accompanying documents (such as, manuals). Read and understand this entire manual before using this bilevel system. Power switch Off (Disconnection from the mains) Power switch On (Connection to the mains) Alternating current Ramp Class II equipment (Double insulated)
User/Owner Responsibility This Respironics Bilevel system and accessories are designed to work as described in this manual. You should not use parts that are damaged, broken, worn out, dirty or otherwise ineffective. Read this entire manual before using this Bilevel system.
Page 5 The Tranquility Bilevel (Model 1700) system from Respironics, is a medical device that uses a blower. The blower is controlled to pro- vide two levels of pressure. The controller allows for the adjustment of the way the pressure changes from one level to the other. The ComfortControlª...
Page 6
8:38 AM Page 6 12. For 12VDC operation, do not use any DC to AC inverter other than that supplied or recommended by Respironics. 13. Check and verify fuse rating before replacement. 14. When using oxygen with this system, make sure that this Bilevel is on before you turn the oxygen source. When you wish to stop using this Bilevel system, turn off the oxygen flow first before turning this Bilevel unit off.
3. Six-foot Hose and Tubing Adapter Carry Case User Instruction Manual You will need a Nasal Mask and Headgear in order to use this system. IF ANY OF THESE COMPONENTS ARE FOUND TO BE MISSING OR DAMAGED CONTACT RESPIRONICS AT ONCE.
Initial Use 1. Prior to each use, inspect this unit for any signs of damage, failure or worn parts. Call Respironics or your Home Care Dealer immediately to replace these parts. Check to see if there is any moisture in the area of this Bilevel unit. Also check the air inlets and outlets for any blockage or the presence of any dust or dirt.
Page 9
1700-00C.QXD 10/21/99 8:38 AM Page 9 Attach the Bilevel Hose to the Air Outlet Port on the front of the Bilevel unit. Attach the Nasal Mask to the other end of the Hose. Refer to the Nasal Mask Instructions for information on using the mask and headgear and on adjusting the fit.
1700-00C.QXD 10/21/99 8:38 AM Page 10 8. Place the Nasal Mask on. Adjust the straps to get rid of any leaks. Do not overtighten the straps. The mask and headgear should fit comfortably. 9. As you breathe in, you will find that the pressure rises slightly. As you exhale, it will fall. This will make your therapy more comfortable.
7. The Nasal Mask, Headgear, and Hose should be removed from the system for cleaning. Humidifier Use An optional Humidifier is available through Respironics for use with the system. The Humidifier is a reservoir that fits under your unit. When properly filled with distilled water, it adds moisture to the airflow.
1700-00C.QXD 10/21/99 8:38 AM Page 12 ing to the T-adapter and the other end to the oxygen source. 2. Oxygen Use Turn on the Bilevel unit so that air flow will begin before turning on the flow of oxygen. When turning the Bilevel unit off, always turn the oxygen flow off first and then the Bilevel unit.
DC Operation Using the Tranquility Bilevel system with a DC power source will require the use of a Respironics DC to AC Inverter (Part Number 7304). When connecting the DC to AC Inverter, turn off the Bilevel system. Connect the AC power cord to the AC receptacle of the Inverter.
1700-00C.QXD 10/21/99 8:38 AM Page 14 Cleaning The System The Bilevel unit can be cleaned using a cloth moistened with water and a mild soap solution. Caution: Unplug the unit before clean- ing it. Do not place the unit in water. Do not use alcohol or other organic solvents to clean this unit. Let the unit dry completely before plugging it in or operating it.
Page 15
1700-00C.QXD 10/21/99 8:38 AM Page 15 PROBLEM POSSIBLE CAUSES INSTRUCTIONS 4. Feeling that the pressure Leak in the system. Check that the mask is not allowing is to high or too low air to leak and that there are no leaks in the hose.
Page 16
1700-00C.QXD 10/21/99 8:38 AM Page 16 PROBLEM POSSIBLE CAUSES INSTRUCTIONS 8. Skin becomes red where Headgear too tight. Adjust the headgear. mask touches skin Wrong size nasal mask. Call your dealer. General irritation or reaction Stop use and call your physician. to the mask material.
1700-00C.QXD 10/21/99 8:38 AM Page 18 PATIENT CHECKLIST As you and your Home Care Dealer discuss the use of your Bilevel system, make sure that you understand the following: Why your physician has prescribed the Bilevel system The importance of using your Bilevel System each and every night How to connect the Hose to the device and to the Nasal Mask How to put on the Nasal Mask and Headgear to achieve a good fit The importance of not blocking the Bias Flow Port on the mask...
1700-00C.QXD 10/21/99 8:38 AM Page 19 SPECIFICATIONS Bilevel Pressure Approx. 3 to 20 cm H Weight 4.8 lbs., (2.3 kg) Height 5.0" (12.3 cm) Length 9.5" (23.6 cm) Width 7.75" (18.9 cm) Electrical Requirements 100-120/ 200-240 VAC 50/60 Hz, 75VA 12 Volts DC with Optional DC to AC Inverter Warranty 1 year limited...
1700-00C.QXD 10/21/99 8:38 AM Page 20 STORAGE AND TRANSPORT Temperature -25¡ C to 60¡ C Humidity 10 - to 95% noncondensing Atmospheric Pressure 790-523mm Hg OPERATING Temperature 5¡ C to 40¡ C Humidity 10 to 95% noncondensing Atmospheric Pressure 790-523mm Hg ELECTROMAGNETIC COMPATIBILITY The Tranquility Bilevel (model 1700) is designed to comply with EN 60601-1-2: 1995, Electromagnetic Compatibility - Requirements and Tests.
ACCESSORIES Respironics offers a full line of accessories and replacement parts for use with the Tranquility Bilevel. These accessories include our standard (1) and Soft Series (2) nasal masks, each available in seven different sizes; a bridge support (3); the Nasal Seal (6), two styles of Headgear (4);...
1700-00C.QXD 10/21/99 8:38 AM Page 22 GLOSSARY OF TERMS Anesthesia A drug that is used to control pain. ComfortControlª A feature of the Bilevel that allows you to change the way pressure is delivered. The act of breathing out Expiration The act of breathing in Inspiration Interference...
Respironics. For the purpose of this Limited Warranty, the initial date of purchase from Respironics shall be the date of shipment from Respironics to the initial owner of record. Should the Unit be defective in material or workmanship during the term of this Limited Warranty, Respironics, at its option, will repair or replace the defective Bilevel system or component parts.
Page 24
Respironics. To obtain service under this warranty, the owner of the Bilevel system must promptly notify Respironics of any defect in materials or workmanship and the serial number and date of purchase of the Bilevel system by calling the toll-free number: (800)345-6443. If Respironics determines that repair is required under this Limited Warranty, Respironics shall provide the owner with a Return Authorization Number.
Need help?
Do you have a question about the Tranquility Bilevel 1700 and is the answer not in the manual?
Questions and answers