Emerson Rosemount 3051S Series Reference Manual page 216

Reference Manual
00809-0200-4801, Rev DA
Parameter Index
SENSOR_CAL 25
_DATE
SENSOR_CAL 26
_WHO
SENSOR_ 27
ISOLATOR_
MTL
SENSOR_FILL_ 28
FLUID
SECONDARY_ 29
VALUE
SECONDARY_ 30
VALUE_UNIT
TB_DETAILED 31
_STATUS
FACTORY_CAL 32
_RECALL
MODULE_ 33
TYPE
SENSOR_CAL 34
_TYPE
FLANGE_TYPE 35
FLANGE_MTL 36
REM_SEAL_ 37
NUM
REM_SEAL_ 38
TYPE
REM_SEAL_ 39
ISO_MTL
REM_SEAL_ 40
FILL
O_RING_MTL 41
DRAIN_VENT_ 42
MTL
PRIMARY_ 43
VALUE_
DAMPING
206
Valid range Initial value Units Other Description
0
See Table 19
and footnote4
1: No Recall 1
2: Recall
3: Save factory
trim
252:
Unknown
See Table 39 252:
Unknown
See Table 50 0
See Table 49 0
See Table 45 0
See Table 46 0
See Table 44 0
See Table 43 0
See Table 48 0
See Table 47 0
0.0f
0.0
F
OUNDATION
N/A The date of the last sensor calibration. This is intended
to reflect the calibration of that part of the sensor that is
usually wetted by the process.
N/A The name of the person responsible for the last sensor
calibration.
E Read Defines the construction material for the isolating
diaphragms.
Only
E Read Defines the type of fill fluid used in the sensor.
Only
SVU Read The secondary value, related to the sensor.
Only
E The engineering units to be used with the
SECONDARY_VALUE.
N/A Read Indicates the state of the transmitter. The parameter
contains specific codes relating to the transducer block
Only
and the pressure sensor specifically.
E Recalls the sensor calibration set at the factory.
If the device is in "factory mode", a value of 3 may be
entered to save the current trim values into a factory
area of NV memory to be used for factory calibration
recall
E Read Indicates the type of sensor module.
Only
E The type of last sensor calibration.
N/A Indicates the type of flange that is attached to the
device. See Flange Type Codes.
N/A Indicates the type of material that the flange is made of.
See Flange Material Codes.
N/A Indicates the number of remote seals that are attached
to the device. See Remote Seal Number Codes.
N/A Indicates the type of remote seals that are attached to
the device. See Remote Seal Type Codes.
N/A Indicates the type of material that the remote seal
isolators are made of. See Remote Seal Isolator Material
Codes.
N/A Indicates the type of fill fluid used in the remote seals.
See Remote Seal Fill Fluid Codes.
N/A Indicates the type of material that the flange o-rings are
made of. See O-ring Material Codes.
N/A Indicates the type of material that the drain vents on the
flange are made of. See Drain Vent Material Codes.
Sec. Time constant of a single exponential filter for the PV, in
seconds.
Fieldbus Block Information
October 2016
F Fieldbus Block Information
OUNDATION