Connections Of Controller With J1939 Engine; Cummins Isb/Isbe; Cummins Qsl9 - Smartgen HGM6100LT Series User Manual

13

CONNECTIONS OF CONTROLLER WITH J1939 ENGINE

13.1 CUMMINS ISB/ISBE

Terminals of controller
Programmable output 1
Starting relay output
Programmable output 2
Terminals of controller
CAN_SCR
CAN(H)
CAN(L)
Engine type: Cummins ISB.

13.2 CUMMINS QSL9

Suitable for CM850 engine control module.
Terminals of controller
Programmable output 1
Starting relay output
Terminals of controller
CAN_SCR
CAN(H)
CAN(L)
Engine type: Cummins-CM850.
HGM6100LT Series Genset Controller User Manual
Table 13 – Connector B
Connector B
39
-
Expand 30A relay, battery
voltage of 01, 07, 12, 13 is
supplied by relay.
Table 14 – 9 Pins Connector
9 pins connector
SAE J1939 shield
SAE J1939 signal
SAE J1939 return
Table 15 – 50 Pins Connector
50 pins connector
39
-
Table 16 – 9 Pins Connector
9 pins connector
SAE J1939 shield-E
SAE J1939 signal-C
SAE J1939 return-D
Remark
Set programmable output 1 as "Fuel
Output".
Connect with starter coil directly.
ECU power;
Set programmable output 2 as "ECU
power".
Remark
CAN communication
(connect to ECU terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Set programmable output 1 as "Fuel
Output".
Connect to starter coil directly.
Remark
CAN communication
(connect to ECU terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
shielding line
shielding line
Page 41 of 50