Table of Contents
Advertisement
mains/gens;
Mains
Line voltage (Uab, Ubc, and Uca)
Phase voltage (Ua, Ub, and Uc)
Frequency
Hz
Phase sequence
Load
Current
IA, IB, IC
Split-phase and total active power kW
Reactive power kvar
Apparent power KVA
Power factor PF
Generator accumulated energy kWh
Output percentage with load
For mains, it has detection functions of over/under voltage and lack of phase; For gen, it has
detection functions of over/under voltage, over/under frequency, over current and over power, and
short –circuit protection function;
Precisely measure and display of parameters about engine,
Temp. (WT),
Oil pressure (OP)
Fuel level (FL)
Speed (SPD),
Battery voltage (VB)
Charger voltage (VD)
Accumulative running hours
Accumulative start times
Control protection: Automatic start/stop of genset, breaker close/open (ATS control) and perfect
fault display and protection;
With ETS, idle control, pre-heat control, speed raise/drop control, all of them are relay outputs;
Parameter setting: Allow user to modify setting and store them in internal FLASH memory. The
parameters cannot be lost even when power off. All of parameters can be set not only from the
front panel, but also use USB interface (or RS485 interface, ETHERNET) to adjust them via PC.;
Multiple sensors of temperature, pressure and fuel level can be used directly, parameters can be
defined by user;
Multiple conditions of crank disconnect (speed sensor, oil pressure, generator frequency) can be
selected;
With emergency start function;
With flywheel teeth numbers automatic identification function;
Widely power supply range: (8~35)VDC, accommodating to different starting battery voltage
environment;
HGM6100LT Series Genset Controller User Manual
Generator
Line voltage (Uab, Ubc, and Uca)
Phase voltage (Ua, Ub, and Uc)
Frequency
Phase sequence
%
ºC/ºF
kPa/psi/bar
%
Fuel remains
r/min
V
V
Hz
L
Page 6 of 50
Advertisement
Table of Contents
