Manual Start/Stop Operation; Emergency Start - Smartgen HGM6100LT Series User Manual

4.4

MANUAL START/STOP OPERATION

1) HGM6120LT: Manual Mode is active when press
mode, press
high speed running. If there is high temperature, low oil pressure, over speed and abnormal voltage
during genset running, controller can protect genset to stop (detail procedures please refer to
No.4~9 of Auto start sequence). Under Manual Mode, switch won't transfer automatically, it is
necessary to manually press
2) HGM6110LT: Manual Mode is active when pressing
press to start genset, it can automatically detect crank disconnect and accelerate to high
speed running. If there is high temperature, low oil pressure, over speed and abnormal voltage
during running, controller can protect genset to stop quickly (detail procedures please refer to
No.4~9 of Auto start sequence). After genset runs well in high speed, press
load.
3) Manual stop, pressing
No.3~7 of Auto stop sequence).
4.5

EMERGENCY START

In manual mode, pressing
controller won't judge whether the controller has started successfully according to disconnect conditions
and the disconnection of starter is controlled by operators. When operators observed the genset has
started successfully, loose the keys and the controller enters safety delay with start stops to output.
HGM6100LT Series Genset Controller User Manual
to start genset, it can automatically detect crank disconnect and accelerate to
to transfer load.
can shut down the running genset (detail procedures please refer to
and
and its indicator illuminates. Under this
, and its indicator is illuminating. Then
simultaneously can compel genset to start. The
and gen takes
Page 12 of 50