Connections Of Controller With J1939 Engine; Cummins Isb/Isbe; Cummins Qsl9 - Smartgen HGM8151 User Manual

16 CONNECTIONS OF CONTROLLER WITH J1939 ENGINE

16.1 CUMMINS ISB/ISBE

Terminals of controller
Fuel relay output
Start relay output
Auxiliary output 1
Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Cummins ISB.

16.2 CUMMINS QSL9

Suitable for CM850 engine control module.
Terminals of controller
Fuel relay output
Start relay output
Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Cummins-CM850.
HGM8151 Genset Parallel Controller User Manual
Table 19 Connector B
Connector B
39
-
Expand 30A relay, battery
voltage of 01, 07, 12, 13 is
supplied by relay
Table 20 9-pin Connector
9 pins connector
SAE J1939 shield
SAE J1939 signal
SAE J1939 return
Table 21 50-pin Connector
50 pins connector
39
-
Table 22 9-pin Connector
9 pins connector
SAE J1939 shield-E
SAE J1939 signal-C
SAE J1939 return-D
Remark
Connect with starter coil directly
ECU power
Set configurable output 1 as "ECU power"
Remark
CAN communication
(connect with ECU terminal only)
Impedance 120Ω connecting
recommended
Impedance 120Ω connecting
recommended
Remark
Connect to starter coil directly
Remark
CAN communication
(connect with ECU terminal only)
Using impedance 120Ω connecting line
Using impedance 120Ω connecting line
shielding line
line is
line is
shielding line
Page 55 of 66