Connections Of Controller With J1939 Engine; Cummins Isb/Isbe; Cummins Qsl9 - Smartgen HGM8140D User Manual

13 CONNECTIONS OF CONTROLLER WITH J1939 ENGINE

13.1 CUMMINS ISB/ISBE

Terminals of controller
Relay Output1
Start relay output
Relay Output 2
Terminals of controller
CAN_SCR
CAN(H)
CAN(L)
Engine type：Cummins ISB.

13.2 CUMMINS QSL9

Suitable for CM850 engine control module
Terminals of controller
Relay Output 1
Start relay output
Terminals of controller
CAN_SCR
CAN(H)
CAN(L)
Engine Type：Cummins-CM850.
HGM8140 Military Genset Controller
HGM8140 MILITARY GENSET CONTROLLER USER MANUAL
Table 16 Connector B
Connector B
39
-
Expand 30A relay, battery
voltage of 01,07,12,13 is
supplied by relay.
Table 17 9 Pins Connector
9 pins connector
SAE J1939 shield
SAE J1939 signal
SAE J1939 return
Table 18 50 Pins Connector
50 pins connector
39
-
Table 19 9 Pins Connector
9 pins connector
SAE J1939 shield-E
SAE J1939 signal-C
SAE J1939 return-D
Programmable relay output1 set as "Fuel Output"
Connect with starter coil directly.
ECU power
Set programmable relay output 2 as "ECU
power".
CAN communication shielding line(connect with
ECU terminal only).
Impedance 120Ω
recommended.
Impedance 120Ω
recommended.
Programmable relay output1 set as "Fuel Output"
Connect to starter coil directly.
CAN communication shielding line(connect with
ECU terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Version 1.2 2019-09-12
Remark
Remark
connecting line
connecting line
Remark
Remark
Page 46 of 56
is
is