Selection Switch Of Rear Pto Clutch Revolutions (P.t.o.); Replaceable End Points Of Rear Pto Shaft - Zetor Forterra CL 100 Operator's Manual

Selection switch of rear PTO clutch revolutions (P.T.O.)

Shifting rear PTO shaft revolutions is done by a switch (1) The switch is equipped with a mechanical lock (2)
against unwanted switch. When switching the switch, depress the lock in downward direction.
540 rpm
A -
1000 rpm
B -
The change of PTO shaft revolutions - 540 and 1000 per minute to be done only with PTO shaft
at halt! Check that the revolutions of PTO shaft are set accordingly with regard for the connected
tools!

Replaceable end points of rear PTO shaft

The tractor is equipped with six or twenty-one splined
replaceable end point of rear PTO shaft.
Replacement procedure:
1. Use safety ring pliers to demount a safety ring (1)
2. Remove replaceable end point by pulling in the
direction of an arrow (2)
3. Mount the end point in an opposite way, pay increased
attention to the mounting of the safety ring (1)
Replacement of the terminal shall be performed
when the engine is stopped.
Rpm of the output shaft and terminal type shall be
chosen depending on the prescribed rpm of the
coupled mechanism.
Shifting 540 and 1,000 or 540E min
regardless to the number of splines of the installed
terminal.
DRIVE OF FARMING MACHINES
FH13N014
-1
is possible
106
E357