Drive Away; Driving Up The Slope; Driving Down The Slope; Warning Signalization Of Air Pressured Drop - Zetor Forterra CL 100 Operator's Manual

Drive away

1. Select road or reduced gears.
2. Depress the clutch pedal.
3. Shift the main shifting lever and the reverse lever to the neutral position and switch off the PTO switches
on the right cab pillar.
4. Start the engine
5. Set the engine speed to 800 rpm.
6. Shift the reversing lever to the requested driving direction of the tractor (forward or reverse).
7. Select the suitable gear for putting the tractor in motion.
8. Slightly increase the engine speed.
9. Get the parking brake ready for releasing.
10. Release the clutch pedal until the travel engagement point and while simultaneously increasing the
engine speed continue releasing the clutch pedal smoothly.
11. Release the parking brake completely.
12. Start moving smoothly and slowly.
Very fast acceleration may cause overloading of the power train, increased fuel consumption, excessive
wear of tyres and damage of the transported load. Only use the 1
driving with a heavy trailer uphill and in rough terrain.
Manual brake - signalization
If the tractor is not braked by a manual brake, a warning is
displayed on a display (a letter P in a circle) and at the
same time there is a sound signal.
This situation occurs in two cases
a - a tractor unbraked by a manual brake with engine
running and a driver leaves its seat
b - a tractor unbraked by a manual brake standing with
engine off and the key is shifted in '0' position.
Brake the tractor with a manual brake.

Driving up the slope

Shift from higher to lower gear in time when
driving up the slope not to have a drop in engine
revolutions under 800 revolutions per minute, do not
allow a drive leading to the engine stop due to
overload.
DRIVING OPERATION DRIVING OPERATION
F11N019
89
st
gear to put the tractor in motion when
FH12N039
F11N020