Table of Contents
Advertisement
Swinging draw-bar console with a fixed pin module
Perform the assembly and disassembly of the swinging
draw-bar in accordance with the 'Swinging draw-bar'
chapter.
Connecting the shaft lug to the fixed pin (3):
1 - Release and remove the pin (1).
2 - Lift the locking wedge (2) in the arrow direction.
3 - Connect the shaft lug to the fixed pin (3):
4 - Return the locking wedge (2) to the original position
and secure it with the pin (1).
Console with a ø 80 ball module
The console with a ø 80 ball is only used to
connect semi-trailers with a hitching device designed
for a ø 80 ball.
Releasing the hitch, fig. (A):
By moving the lever (1) in the arrow direction you will
remove the locking wedge (2).
Locking the hitch, fig. (B):
By moving the lever (1) in the arrow direction you will
retract the locking wedge (2).
Hitch for a single-axle CBM semi-trailer
The hitch for a single-axle semi-trailer may be equipped
with a hook (A) or with a swinging draw-bar (B).
Replacing the hook with the swinging draw-bar (C):
1 - Lower the hitch.
2 - Release and remove the pin (1).
3 - Remove the hook in the arrow direction.
Install the swinging draw-bar in the reverse order.
Uncoupling of a single-axle trailer
Lift up the arms of the rear three-point hinge to the upper
position when the maximum position regulation is set.
Move the lever of the hinge control for one-axle trailer
from the position (a) to the position (b) (the lever is located
on right side of the drivers seat).
Lower the arms of the rear three-point hinge. This way the
hinge for the one-axle trailer is lowered as well and the
drawbar eye of the trailer can be disconnected from the
hitch hook.
When released, the lever of the hinge control for one-axle
trailer is returned from the position (a) to the position (b)
automatically.
TRANSPORT USE
99
D206
D207
D208
F15N035
Advertisement
Table of Contents
