Rear Pto Switch; Engaging Rear Pto Shaft - Independent Revolutions - Zetor Forterra CL 100 Operator's Manual

Rear PTO switch

Rear PTO shaft clutch is engaged by switch of rear PTO shaft. After engagement of the switch the shaft
spins.
The engagement of the rear PTO clutch is done by a switch (1) placed on the right column of the cabin. The
switch is equipped with a mechanical lock (2) against unwanted switch. When switching the switch, depress
the lock in downward direction.
After switching the switch (1) from (A) position to (B) position rear PTO shaft clutch is engaged and the shaft
spins.
After switching the switch (1) from (B) position to (A) position rear PTO shaft clutch is engaged and the shaft
stops.
A - rear PTO shaft clutch disengaged
B - rear PTO shaft clutch engaged
Check that the PTO shaft revolutions are set properly with regard for the connected tools!

Engaging rear PTO shaft - Independent revolutions

The number of PTO shaft revolutions is dependent on the number of engine revolutions.
With engine running:
1. Select applicable operation mode PTO shaft revolutions preselection lever.
2. Select applicable revolutions by switch of selection of rear PTO shaft (2) revolutions.
3. Rear PTO shaft is set into operation by switching the switch of rear PTO shaft (3).
Engagement of rear PTO shaft is signalized by the display of the number of rear PTO shaft revolutions on
the display of the dashboard.
If the aggregated machine allows it, engage the rear PTO shaft with minimum revolutions of
1500 rpm.
DRIVE OF FARMING MACHINES
C15N016
F15N040
107