Setting Wheel Stops With Front Drive Axle - Zetor Forterra CL 100 Operator's Manual

Setting wheel stops with front drive axle

Set the stops always with any wheel track change or tire
replacement with front drive axle.
Wheel stops with front drive axle must be set so that there
would be a distance of at least 50 mm between front drive
axle tires and tractor with full lock and full axle swing
around central pin.
Setting wheel stops with front drive axle check
1. Set full lock to one side and check that the distance
between a tire and the nearest solid point on the tractor is
at least 50 mm. Check both front tires.
2. Turn the steering to full lock to the other side and check
according to point 1.
3. Heave one side of the front axle to the maximum swing
(front axle leans against the bracket) and check according
to point 1 and 2.
4. Hoist the other side of front axle to the maximum swing
(front axle leans against the bracket) and check according
to point 1 and 2.
The setting of stops (A) changes after the release of a nut
(2) and unscrewing or screwing in a screw (1).
After the change in setting wheel stops with
front drive axle, it is always necessary to check their
setting according to points 1 to 4.
Rear wheels wheel track
Gauges of the tractor rear wheels equipped with screwed footer discs
Depending on the width of the rear tyres you can set the wheel tracks in the following range:
Rear tyre width Wheel track
(mm)
12,4-38 1425 - 1800
13,6-38 1425 - 1800
18,4-38 1650 - 1800
480/70R38 1575 - 1800
520/70R38 1650 - 1800
16,9-34 1500 - 1800
16,9-38 1575 - 1800
18,4-34 1500 - 1800
Note: Use of different tyre dimensions with individual tractor types - see chapter Main technical parameters.
WHEEL TRACK CHANGE
136
F13BN033